P1PV / P1PVCD Series
Installation & Service Instructions
030099-347 Rev. 2
pg 6 of 16
© Copyright 2007 OASIS Corporation
f)
Press the dispensing button for cold temperature water and keep the button depressed until the
water from the outlet runs clear – note that it will take some time to bleed all of the air from the
cooling tank
g)
Carry out a visual inspection for any water leaks
h)
Disconnect the power supply and water supply from the cooler
i)
Drain the water cooler (see relevant section below)
7.
Replace the shipping bag over the water cooler
8.
Replace the carton over the top of the cooler
9.
The cooler is now ready for transportation to the customer’s premises
NOTE: Whenever you transport the cooler to or from your premises, you should ensure that a
shipping bag is placed over the cooler. This will prevent damage to the cabinet caused by coolers
rubbing against one another in the back of the truck or van.
Draining the Water Cooler:
•
Isolate the water cooler from the mains water supply – this may be done by closing any shut-off
valve fitted to the installation or temporarily disconnecting the cooler from the water supply
•
Disconnect the cooler from the power supply
•
Remove the top from the unit – remove the two screws at the rear of the top, and lift off the lid
assembly
•
Looking down on the unit,
disconnect the cold water
inlet as shown in the
diagram to the right.
