B_1RREC / POU_1RREC Series
Installation & Service Instructions
030099-499 RevOrig
pg 12 of 22
© Copyright 2014 OASIS Europe
Cooler Installation:
The general installation guidelines below should be followed:
•
The cooler must be located on a floor that is smooth, level and easily cleaned.
•
Do not locate the cooler in direct sunlight.
•
Do not locate the cooler next to a radiator.
•
Do not locate the cooler within or directly adjacent to toilet facilities.
•
Do not locate the cooler in constantly damp areas, beneath dripping pipes, or where water may
collect underfoot.
Examine the proposed cooler location for the following:
•
Location of electrical supply
o
The cooler should be installed no more than 2 meters (6 feet) from the nearest electrical
outlet.
o
It should be possible to access the plug when the cooler is in its final position.
•
Location of potable water supply
o
The cooler must be attached to a potable water source.
o
The length of small bore tubing (usually ¼”) used to connect the cooler to the water
supply should be kept to a minimum and must not exceed 20 meters (65 feet).
o
If the planned cooler location is more than 20 meters (65 feet) from the connection point
to the water source, then an additional water supply line should be added.
BOTTLE VERSION
TO PUT BOTTLE WATER COOLER INTO SERVICE
1.
This unit is suitable for indoor use in domestic, commercial & industrial locations. They should
not be sited in locations where they may be subjected to rain or snow.
2.
Carry the cooler in the upright position to the customer’s premises - use the handle at the rear of
the unit.
3.
Remove the shipping bag from the cooler.
4.
Carry out a general inspection of the cooler, ensuring that :
a.
There are no marks or physical damage to the cooler.
b.
That all accessories are present.
c.
That all the wires and electrical connections are in place at the back of the cooler.
d.
That the cooler is clean and dust free.
5.
Level the machine using the adjustable feet
6.
The water cooler should be located a minimum of 2" from the wall to assure adequate condenser
air circulation.
7.
The unit should be operated with the stability cord at the rear of the unit fixed to the wall at all
times.
8.
The stability cord wall fixing should be mounted securely to the wall at a height of 660mm from
the floor. The unit should be located approximately 140mm from the wall. Ensure that the cord is
taut.
9.
Power cords fitted to the cooler must be tied securely to the back of the unit (base) using the cord
re-strainer supplied, in such a way that it is not possible to remove the power cord from the
appliance by pulling on the flexible cord.
10.
Bottles should be no larger than 19 litres
