B_1RREC / POU_1RREC Series
Installation & Service Instructions
030099-499 RevOrig
pg 19 of 22
© Copyright 2014 OASIS Europe
5.
Remove the faucet cover as follows:
o
Press up the bottom of the cover, clearing the bottom hooks of the mounting holes
o
Drop the cover to unhook the upper clips
o
Remove the cove forward over the faucet levers
6.
Disconnect the lead wires from the solenoids
[Electronic version only]
7.
Unscrew the two faucets from the reservoir by turning the faucets counter clockwise.
8.
Remove spout
9.
Remove the Drip tray & unscrew hidden screws x2 in alcove
10.
Remove alcove (pull forward)
11.
Rotate & detach lower parts of faucet FTG’s (1/4” turn bayonet connection)
12.
Unscrew upper parts of faucet FTG’s from reservoir
13.
Grasp the top of the reservoir around the opening and pull upward in a straight motion.
Note:
Take care when removing the reservoir that any water remaining in the bottom of the
reservoir, does not fall into the appliance
Installing New Reservoir
1.
Align the reservoir with the probe. Place one hand inside the reservoir on the sleeve and push
downward on the reservoir until it is resting on the insulation.
2.
Reattach the upper faucet FTG’s to the reservoir by turning them clockwise, ensuring that
o
They are on the correct thread with the reservoir.
o
The beige FTG is on the left hand side of the cooler
o
Both FTG’s are oriented downward
3.
Reattach the lower faucet FTG’s to the upper FTG’s (1/4” turn bayonet connection), ensuring
that
o
The beige FTG is on the left hand side of the cooler
o
Both FTG’s are oriented forward
4.
Insert alcove ensuring that the Carbo FTG is located
5.
Reattach spout
6.
Replace screws x2 behind Drip tray
7.
Reattach the faucets to the reservoir by turning them clockwise, ensuring that
o
They are on the correct thread with the FTG.
o
The blue faucet is on the right hand side of the cooler
[Mechanical version only]
o
Both faucets are oriented so that their outlets align with the holes in the cover
8.
Reattach solenoid leads
[Electronic version only]
9.
Reattach faucet cover as follows:
o
Insert two upper clips into holes in the alcove below buttons
o
Push cover over faucets
o
Press lower clips into mounting holes
