3
Scope of delivery
Casing
Base (pre-assembled)
Weight segments
330R
Mounting tube
Upper flexible clamp
Lower flexible clamp
330R with quick clamp accessory QC2
Mounting tube
Quick-release clamp
Reducing sleeves
Telescoping rod
Adhesive pads
allen key
Screwing
open end wrench
Equipment
Danger of injury. To protect yourself against injury, you must wear the following clothing
during assembly of the sunshade stand:
Sturdy shoes
Work gloves
In addition, you will need the following materials and tools
Allen key (included)
Soft blanket, etc. to place beneath parts during assembly
i
Besides the tools included with the stand you will need no other tools for
assembly
Check conditions for assembly
Make sure that the assembly location fulfills the following conditions. The assembly
location must be:
level,
sufficiently firm for bearing loads,
large enough for assembly of the stand
insensitive to scratches and impacts
Assembly
The sunshade stand must be assembled as follows:
1.
Place the blanket, etc. on the ground to prevent damage to the
underlying surface a and the parts during assembly.
2. Fig. 2:
2-men handling
Setting down the weight segments and the base
Set down the weight segments and the base (with the rollers facing downward) on
the ground
3. Stick eight adhesive pads to the bottom (flat side) of each weight segment as
shown in the figure (Fig. 3).
4.
Danger of pinching and danger of cuts/scrapes. Wear gloves and place the weight
segments carefully and one at a time on the bottom support plate (Fig. 4) of the
base. Push the weight segments all the way back so that they are held firmly in
position by the holding pins.
4
Assembly of the sunshade stand
4.2 Assembly
8
13
