Oasis SmartChem - INSTALLATION AND OPERATION MANUAL
Page
8
of
22
Controller Connection
1. On the Oasis Smart Master Controller, you will need to enter into the Expansion Unit portion of
the menu. Do this by pressing the Menu button until you see 1. Filter Times appear, scroll down
to 6. Installer setup and press Enter. You will see 6-1. Appliances, scroll down to 6-10 Expansion
Units and press Enter.
2. Once you Enter into 6-10 Expansion Units, you will be pressing Enter to get through all the setting
to do with the normal Expansion Units. The controller will display:
o
EXP:1 1.00B1 *
o
EXP:2 NONE
o
Press Enter and the controller will then display:
o
NUMBER EXP
o
UNITS 1
o
Press Enter and the controller will display:
o
RESET ALL
o
ADDRESSES NO
o
Ensure that NO is displayed and press Enter. The controller will display:
o
SCAN FOR EXP
o
UNITS NOW? NO
o
Ensure that NO is displayed and press Enter. The controller will then display:
o
SMARTCHEM
o
V1.00B07 (If already received, otherwise this line will be blank)
3. If the version number is already displayed then the
Oasis SmartChem
is now active to be utilised
through the App (go to page 7 Of this guide) and you can exit the menu by pressing the Menu
button, or if you need to reset the
Oasis SmartChem
unit press Enter and see below for further
instructions.
4. If the lower line was blank, press Enter and the controller will display:
o
RESET
o
SMARTCHEM NO
5. If you would like to Reset the
Oasis SmartChem
or install another unit, use the ↑ or ↓ buttons to
change from NO to YES and press Enter. The controller will then display that the “Reset Done”,
press Enter to move to the next function.
6. If you are setting up the
Oasis SmartChem
for the first time, make sure the controller has NO
displayed and press Enter. The controller will display:
o
SCAN SMARTCHEM
o
NOW NO
7.
If you don’t want to scan for an
Oasis SmartChem
, make sure the controller is displaying NO
and press Enter and the controller will exit you to the Installer Menu.
8. If you have Reset the
Oasis SmartChem
or are setting it up for the first time you will use the ↑ or
↓ buttons to change from NO to YES and press Enter. After a few seconds of searching, the
controller will then display:
o
SMARTCHEM
o
V1.00B07
Once it does, the
Oasis SmartChem
is now active and can be utilised through the App and you can
exit the Expansion menu by pressing the Menu button on the controller.
