Oase SwimSkim 50, Operating Instructions Manual

Page: 11 / 96

- EN -
11
Wear parts
Impeller (20) and foam filters (7) are wearing parts and are, therefore, not covered by our warranty.
Storage/Over-wintering
Remove the unit at temperatures below zero degrees centigrade. Clean the unit thoroughly, check for damage and
store immersed in a frost-free environment. Ensure that the power plug is not flooded.
Remedy of faults
Malfunction Cause Remedy
The unit does not switch on No mains voltage Check mains voltage
Air in the pump housing Pull the power plug; for venting, tilt the unit to-
wards the skimmer flap
Insufficient delivery rate Impeller blocked Clean
Filter basket soiled Clean
No aeration Air hose kinked or disconnected Ensure secure fastening and avoid kinks in the
air hose
The air hose is not inserted up to the mark in
the intake socket Correctly position the air hose in the intake
socket
Unit switches off after a brief running time (ap-
prox. 10 s) Water temperature too high Note maximum water temperature of +35°
Pump run dry Clean pump and unit For switching on again,
pull the power plug and reinsert in the socket
The unit floats up Filter basket full or clogged Switch off the unit and clean filter basket
Unit floats up, pump is switched on Impeller soiled Switch off the unit and clean impeller
Disposal
Dispose of the unit in accordance with the national legal regulations.