Oase OxyMax 100, Commisioning Manual

Page: 14 / 120

14
Installing the aerator
 B
•
Always install the unit higher than the water level. This prevents water
from possibly flowing back into the pump.
•
Use the fastening lug for installation.
•
Route the power connection cable such that it forms a drip loop.
During installation, ensure that the unit
•
is installed outside of the aquarium,
•
is not placed on or over the aquarium,
•
cannot fall into the water or move out of position.
Commissioning/start-up
NOTE
Never run the aerator without a hose and air discharge.
Switching on: Connect the unit to the mains. The unit switches on immedi-
ately.
Switching off:
Disconnect the unit from the mains.
Adjusting the air quantity and bubble pattern
 C
Air quantity:
Adjust the air quantity by turning the air connection control
knob.
Bubble pattern:
Take the aerator out of the water and adjust the bubble
pattern at the aerator using a coin. Adhere to the safety instructions!