Oase LunAqua Classic LED Set 1, Operating Instructions Manual

Page: 9 / 14

- EN -
14
Cleaning
Attention! Dangerous electrical voltage.
Possible consequences:
Death or severe injury.
Protective measures:

Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water:
Isolate the units and installations (switch off and disconnect from the power supply) before reaching into
the water.

Isolate the unit before starting any work.

Secure the unit to prevent unintentional switching on.
If necessary, clean the unit with clear water using a soft brush.

Ensure that no moisture can enter the unit.
Replacing the bulb
An LED chip, fixed by a socket and thermal paste in the spotlight, serves as the light source. After removing the chip, it
is necessary to remove the residual thermal paste and apply new thermal paste.
How to proceed:

J
1. Use a leather or textile cloth (for a better grip) to hold the front cap and unscrew it counter-clockwise.
2. Gently tap to remove the protection lens, O-ring and reflector from the lamp.
3. Undo the small screws on the LED chip holder and lift the chip holder up. Then remove the LED chip itself from the
bottom of the housing.
– When lifting up the chip holder, take particular care not to damage the electrical connection.
4. Apply a small amount of new thermal paste to the bottom of the housing and spread it using a credit card or similar.
The layer of paste on the bottom of the housing must be large enough to cover the entire bottom surface of the new
LED chip when it is in position.
5. Align the LED chip such that its plus and minus pole make contact with the plus and minus pole of the chip holder.
6. Assemble the spotlight in the reverse order.
7. Use the O-ring supplied with the LED chip.
– Ensure that the O-ring sealing surfaces are clean.
8. Screw on the front cap clockwise as far as possible.
Repair
Neither the driver nor the LED spotlight can be repaired in the event of damage to the cables or the housing and have
to be replaced. For your own safety, consult a qualified electrician or your specialist dealer if you have any questions or
encounter any problems.
Storage/Over-wintering
The spotlights and driver have to be removed and stored in a dry place if temperatures outside the permissible ambient
temperatures are expected.
Wear parts
The following components are wear parts and are excluded from the warranty:

LED chip
Disposal
Do not dispose of this unit with domestic waste! For disposal purposes, please use the return system provided.
Disable the unit beforehand by cutting off the cables.
Downloaded from www.watergardeningdirect.com