Questions, problems, missing parts?
Before returning to your retailer, call us at 1-866-627-3435, 8 a.m.-6 p.m., EST, Monday-Friday, or
email us at [email protected]. Or visit our website at www.oase-livingwater.com
- English -
5
4
1.
Start-up
Attention! The pump must never run dry.
Possible consequences:
The pump will be destroyed.
Protective measures:
Check the water level at regular intervals. Always place the unit below water level and make
sure it is floating.
Attention!
The installed temperature sensor automatically turns the pump off, if it is overloaded. The pump
automatically switches on again once the motor has cooled down.
Risk of accident!
Install the unit so that it is not exposed to direct sun radiation (max. 104 ºF - 40 ºC).
!
Important:
●
The unit switches on automatically when power connection is
established.
●
The light is designed to turn on when it gets dark, and turn off when it
gets light. To activate the light during daylight hours, cover the sensor.
1. Switching on:
Connect power plugs to the socket.
2. Switching off:
Disconnect the power plugs.
!
5.
Connect the sensor to the transformer by pushing the
plug into the transformer socket until it is firmly seated.
Hand tighten the nut from the plug to the socket.
6.
Use a knife to cut 3 pieces of tether Line, line length
depends on your lake size, attach one side of each line to
one of the three loops.
7.
Place the fountain into the water and tether it with
supplied line and ground anchors into desired location.
Installation (cont.)
1/4 HP
5.
6.
B
C
D
B
C
D
B
C
D
7.
1/4 HP
ground anchor
line
