Set the charging model
OFF: RFID mode; ON: Autostart mode
Reserved
2
3
4
Set the DIP switch
Installation instructions
Follow these instructions to configure the DIP switch.The
following illustration shows an enlarged view of the DIP and
rotary switches.
●
Warning
Power MUST remain OFF before setting or changing the DIP or
rotary switches.Changing these switches with the power ON will
not be recognized by the system and is dangerous due to the
risk of electric shock.
1.Turn OFF power.
2.Use a non-conductive object (such as a plastic pen) to adjust
the DlP switch settings.
3.Set 4 DIP switches to off position as factory default.
Reinstall the sealing cover and
Turn on power
① .
Use a screwdriver to lightly secure the sealing cover by
installing only the top screws at
(
1.5NM-2.0NM )torque.
②.
After sealing cover fixing, put the facia on and fix it on the
sealing cover.
③ .
If you need to open the front cover, change the internal
settings, please use the
④
plastic lifter to unclench along the
edge of the cover.
④.
Recommend to install a circuit breaker 40A/2P 30MA.
●
●
●
1 2 3 4
ON
OFF
Operating status
Power on checking
NO.
1
2
3
4
5
6
Check content
Check and ensure the circuit breaker for the EV
charger is reasonably selected
Confirm that there is no short circuit between the
AC output L/N/PE of the charging
Confirm that the charging gun is not connected to
the vehicle
Ensure the circuit breaker is closed
The charger is powered on, and the power-on selfcheck is
completed in about 10 seconds
After the power-on self-check is completed, observe
the status of the LED
indicator.Normal standby: Green breathing light ON.
Equipment Failure: Yellow light on /Red light on (Please find below for reference)
LED light instructions
P-17
P-18
①
②
③
DIP switch
position
1
Functions
Stop grounding detection function
OFF: Start the detection; ON: Stop the detection
Set the DLB function
ON: Stop DLB function;
OFF: Start the DLB function(optional)
④
●
EV charger
No power
Power on checking
Stayby
Plug the connector without swiping RFID
(not ready to charge)
LED light
LED off
Plug the connector without swiping RFID
(ready to charge)
Green,yellow,red lights on and off
Green light on
Streaming light runs back and forth
Streaming light runs fast back and forth
Plug the connector with RFID swiped
(not ready to charge)
Charging
Streaming light runs from
two ends to the middle
Streaming lights from the
middle to up and down
RFID initiated without charger inserted
Green light on the upper, last for 1 min
Charing without current
LED lights runs from middle to
the end (not to the bottom).
Charging completed
All lights on green
