O&O CSB-XT, Installation And Operation Manual

Page: 22 / 64

- 22 -
6.4
3ND
LEVEL PROGRAMMING
Par Function Settable data

Advanced setup
 : no advanced setup

 : input open at on state (reserved)

PDM dynamic input polarity
 : input N.O.

 : input N.C.

Output 2 polarity
 : N.O.

 : N.C.

Output 3 polarity
 : N.O.

 : N.C.

Output 4 polarity
 : N.O.

 : N.C.

Opening speed (%)  - 


Closing speed (%)  - 


Speed selection input
 : Disabled
 : Enabled

Exiting the menu/saving
Exit programming and view machine statuses (see notes  St auto-
mation statuses display after the 1st level table)
Available functions only for CSB-SP/XT
Description of level 2 parameters
·

: Request for maintenance
-  : the request for maintenance is not active.
-  : at the end of the countdown, by means of counters  and  , one of the programmed outputs is activated (see parameter
 ,  ,  )
-  : at the end of the countdown, by means of counters  and  , one of the programmed outputs is activated (see parameter
 ,  ,  ) and the bar lights fl ash twice.
·

 and 

: Programming maintenance cycles in thousands and millions
Thanks to the combination of the two parameters the countdown can be set after which a request for maintenance is signalled.
Thousands can be set with the
 parameter, millions with the  parameter.
Example: to set 275,000 maintenance manoeuvres set  on 0.2 and  on 75.
The value displayed in the parameters updates along with the manoeuvres.
· Arm locking device con fi guration:
To use the arm locking device, connect the enabling contact to OUT2 or OUT3 or OUT4 and set the corresponding parameter
 ,  or  to  .
Par Function Settable data

Output 4
 : request for maintenance

 : photocell triggering
  : reverser triggering
 : PDM contact actuated
 : arm closed
 : arm open
 : stop contact actuated
 : warning fl ash
 : Arm locking device

Exiting the menu/saving
Exit programming and view machine Statuses (see notes  automa-
tion Statuses display after the 1st level table)
The following table gives the 3rd level functions and the single parameters.
= DEFAULT value set in factory.
= parameter value set during installation: must be indicated if
DEFAULT value is modi fi ed.