IMPORTANT
8
5.
Follow the cord for the foot control back to the place where it
connects to the control box. Press down on the cord connector tab and
unplug the foot control.
6. Pull on the foot control’s cord enough to enable you to reach the
plastic cord restraint that holds the cords in place (the hand
control coil cord enters the control box here as well). Remove the
plastic cord restraint by just applying a little pressure to one side.
Slide the foot control cord out of the slit in the restraint. Discard
the inoperable control.
7. Take the new foot control and thread the straight section of cord
closest to the plug into the slit of the plastic cord restraint. The
cords for both the hand control and the foot control will fit in to
this slit. Place the plastic cord restraint into the hole in the
bottom plate of the control box bracket and push it into place
using slight pressure until the cord restain flange is flush against
the control box bracket.
TR OUBLESHOOTING
CAUTION
Before doing any work on the
unit,disconnect the power
cord from the power outlet.
Be careful of slack in the
power cords as you put the
control box back in the
cabinet to avoid pinching
cords between the cabinet
base and the control box
bracket.
20
TROUBLESHOOTING
• Foot Control Replacement Instr uctions
T
R
O
U
B
L
E
S
H
O
O
T
IN
G
CAUTION
• Foot Control
(cont)
CAUTION
The table weighs as much
as 300 lbs.
DO NOT
lift or
move the unit without using
proper safety procedures
or equipment.
DO NOT
turn
the
C
elesta
G
emini
™
on its side
for any reason. To do so
could cause damage to the
base and
will
void the warranty.
There are no serviceable
items that require this action.
Never lift the table by grasp-
ing the table top as the
table top is not designed to
hold the weight of the base
and you could damage the
table.
IMPORTANT
8
