Oakton TEMP 9000, User Manual

Page: 6 / 25

6
Pressing and holding UP and DOWN arrow keys will increase or decrease text entries without
an acceleration factor. The LEFT arrow button allows you move backwards through the GEN-
ERAL SETUP MENU (GSM) and ADVANCED SETUP MENU (ASM). While in the ASM, you
can move backwards to the first ASM screen, but cannot back into the GSM. To exit to the
main screen from either menu, press and hold the MENU button.
HEAT, COOL, AND TUNE
When any of these modes are active they will have a block
indicator on the display showing they are active. Example:
When the control is in the heat mode and it is applying pow-
er to the heater output there will be an indicator block on the
display to show the heater output is active.
BACK OF CONTROL SHOWN WITH 230 VOLT OUTPUT RECEPTACLE
Model 89800-01 & 89800-02
1. IEC power cord connection (see page 23 for additional cords)
2. Fuse
3. Heater/Cooler output (IEC 60320 on 230 volt, 5-15R on 115 volt) see page 24, 25 for op-
tional country cord adapters.
4. Control Power Switch
5. Grid Support Bracket
6. Thermocouple, Type: J, K, N, R, S, T, B, and E
How to Setup models: 89800-01 & 89800-02
•
Install control in safe operating area.
•
Plug Heater/Cooler into the output connector, located on the back of the control.
•
Connect input sensor into the proper connection input on control and place the sensor in
the process.
•
Plug proper AC cord into the IEC connector (depends on country), located on back of the
control.
5-15R ,
115 VOLT