4 Mode
4.1 Mode - SETTING
7 / 18
screeneye
x
button, confirm with the middle button. Proceed the same way with
the remaining digits. (optional)
The calibration factor can only be set, if the EXPERT View is active
(see chapter 4.1.4 VIEW)
Calibration of the stride sensor improves the accuracy of speed, pace
and distance measurements. It is recommended that you calibrate the
stride sensor before using it for the first time, if there are significant
changes in your running style, if you have new shoes or if you switch
the sensor from your right shoe to your left one. The calibration
should be done at the speed you normally run.
The calibration factor is calculated from the measurement results in
relation to the known path length.
calibration factor = known path length / measured length with sensor
Example:
known path length = 10km
measured length with sensor = 9,940km
calibration factor = 10 / 9,940 =
1.006
The current setting is blinking. Choose the temperature scale
“C” or
“F” by pressing the front button
and confirm with middle button.
The temperature is displayed only. It is not stored and not transmitted
when reading the data into the computer.
Off is blinking, press the front button to turn on the lap mode. The
current distance is shown. Press middle button to set the distance for
a lap. The first digit is blinking, adjust the value by pressing the front
or rear button, confirm with the middle button. Proceed the same way
with the remaining digits. (optional)
The A.LAP value can only be set, if the EXPERT View is active (see
chapter 4.1.4 VIEW)
This value is the specific distance for one lap. If it is set, the lap will
increase automatically (while the stopwatch is running) when the
distance is reached (this function is optional and works only with the
max
run foot pod sensor). Read chapter 4.3.1 Stopwatch for further
information.
4.1.3
Setting - PAIR
What is pairing?
Pairing is the connecting of sensors, e.g. your heart rate monitor with
the
screen
eye x. After you have paired the first time, your
screen
eye
x automatically recognizes the paired sensor each time it is activated.
This process occurs automatically when you turn on the SPORT
mode and only takes a few seconds when the sensors are activated
and begin functioning correctly. Once paired, your
screen
eye x
TEMP
A.LAP
