Installation
10
・
Fit the engine to four Engine brackets simultaneously.
・
Fasten the four engine support bolts only hand tight at first to align the engine. Then tighten the bolts
with a hex wrench.
・
Fasten the engine support bolts next. Do not forget to use Nord-Lock washers otherwise engine
vibration will loosen the bolts and cause a failure.
・
Make sure of the Manifold pressure tube is installed as shown below.
Engine support bolt
The tube to measure the manifold pressure
Add the pair of Nord-Lock Washers to the support bolt.
Check this step very carefully. The key faces on inner surface,
and radial teeth on the outer suraface.
Engine support bolt
Summary of Contents for GF40U-FI
