O.S. engine GF40U-FI, Instruction Manual

Page: 6 / 36

Accessories
5
【
Igniter
】
Model:IG-08A
・
The red connector is a power connector. Supply DC6V
～
12.6V
(MAX1A) for operation. The ignitor requires a separate power
source from that of the ECU. Install a power switch outsidfe of a
fuselage between Ignitor and power source for safety.
・
Connect the black connector to Ignition signal cable of ECU
【
Spark plug
】
・
Screw into the engine's cylinder head.
・
NGK CM-6 Spark plug.
・
the hexagon size is 14mm.
・
Tightening torque is 12N
・
m
【
Fuel filter
】【
Non-bubble weight
】
・
Inline fuel filter to be used between a fuel tank and a pump. The
arrow mark shows the direction of fuel flow.
・
Non-bubble weight to be used in a fuel tank to avoid air bubbles
in fuel line.
【
Hose clamp
】
・
To be used to fix pressurized tubes to joints.
・
Recommended tube: EIGHTRON Flexible Fluorine (ETFE) Resin
Tubing Clear made by HAKKO CORPORATION / JAPAN
Code No.28382303 FLUORINE(ETFE) RESIN TUBING (2m)
※
Be sure to use this tube where pressure is applied.
【
Connector lock
】
・
For crankshaft rotation sensor
，
the power connector of Igniter
，
and Ignition signal connector to prevent connectors from
disconnecting.
【
Socket wrench (SST)
】
・
A special tool for attaching and detatching the temperature
sensors. (intake air temperature sensor and cylinder head
temperature sensor)
・
Attach this tool to 1/4"(6.3mm) Socket wrench handle. (Socket
wrench handle is not included in this set)
【
Serial signal converter
】
・
To be used to convert UART serial signal from ECU to RS-232C
serial signal when ECU is connected to a computer.
【
Power supply code
】
・
Supply power.
・
DC10V
～
17V(MAX1.5A)