22
Installation of fiber handling parts on the AUTOCLEAVER LDF
™
1.
Install the linear inserts in the fiber holder clamp vice (mounted on top of the cleaver) as shown in the image
below. Hold the two parts pressed together and slide them into position. The inserts are held in place by the
two pins and magnets.
2.
Remove the front cover for the v-groove clamp (held in place by magnets) and place the v-groove clamp block
(towards the v-groove clamp cylinders) in position. Make sure the v-groove slide ramp is clean and free of
debris.
3.
Remove the rear cover by unscrewing the two hexagon screws holding it down with the supplied 2.5 mm Allen
key.
4.
Place the height adjustor, make sure that the spring is located in the small hole at the back of the fixed clamp
block and that the pin from the miniature cylinder is fitted into the hole of the height adjustor.
5.
Mount the front and rear cover back, and tighten the two hexagon screws in the rear cover just until you feel a
small resistance. Do not over tighten.
This concludes the installation of the fiber handling parts on the AUTOCLEAVER LDF
™
- Fitel Edition.
