Figure 6. MIMXRT1170-EVK board with highlighted jumper settings (valid also for MIMXRT1160-EVK)
For a correct connection, the motor-control application requires remove and solder some resistors. Please, solder resistor R1841
and R1842 for encoder and remove resistors R188 and R193 for right ADC measuring. These resistors are located on the top of
the EVK board. For more details, see the schematic.
NXP Semiconductors
Hardware setup
MCUXpresso SDK Field-Oriented Control (FOC) of 3-Phase PMSM and BLDC motors, Rev. 0, 01/2022
User Guide
8 / 50
