Appendix III: Wiring Diagram for R&G Light Interface
Appendix IV. Drive Requirement for Main Control Board
Wire Control
Red & Green light
interface
Red light
Green light
Com wire
Red light wire
Green light wire
Connect R&G light power
Red
Com
Green
Two types of remote control, multi frequencies for choice. If need to
add or change remote control, methods as following:
1. Learning type
Learning method 1: Before connect power to the barrier gate, keep
pressing button “STOP”, then connect to power, after about 6
seconds, indicator of the receiver from lighting to flashing 4 times
then oFF. That means learning well. (Note: during learning, please
don't loose the button, or you need to relearn).
Learning method 2: Press button “UP” and “STOP” of the well
learning remote controller at the same time for 4 seconds, indictor of
the receiver keep lighting means entering to learning status; during 3
seconds, press button “STOP” of the not learning remote controller
for 2 seconds (or press 2 times continuously), indicator of receiver
flashes 4 times. That means learning well. If the remote controller
doesn't receive any eFFective signal, it will quit learning status.
Clear the code of remote controller: take out the cover of the radio
receiver, and power on, then make short circuit of the left 2 dial plate
on the receiver mould, until the indicator goes out. Then the code of
remote controller is cleared.
2. Fixing type:
The code of remote controller and receiver should be the same.
Coding method: open the remote controller, take out the battery, there
is dial plate, the direction is from right to left. The solder between
middle port and top port is state “1”. The solder between middle port
and bottom port is state “0”. Empty is state “X”. The code as below is
10XX0X1X (Warning: please take out the battery before coding!).
Appendix II: Remote Control Coding
Top
“
1
”
is connected with
the18th DIP of the ic
Right
“
0
”
connects
with
Bottom
the
9th
DIP
ofthe
IC
Left
H
L
1
8
Line length<5m
Main control
board
Optocoupler PC817
COM
Optocoupler control mode
Relay control mode
Main control
board
U
P
COM
Drive time>=200ms
Drive time>=200ms
Line length<=10m
12
.
.
13
.
.
