P
age 46 of 85
5368 KUHL ROAD
●
ERIE, PENNSYLVANIA 16510
●
PHONE 814-899-4220
●
FAX 814-899-1410
A member of the Medical Illumination International Group
Section 3
Track Mount Installation Procedure
•
Ensure the cable carrier chain lays flat within the track. Attach the Molex connector to the
mating connector on the trolley assembly. See figures 29 and 30.
•
If the cable carrier and trolley move properly along the track, replace the two stop pins and
screws at the open track end. Carefully slide the center dress covers through the trolley. Be
careful not to damage the trolley components, wire connections, or the covers when
installing these back. Tighten the three set screws along both sides of the track to secure the
covers in place.
•
Reinstall the side panels and secure in place with the wood screws. Ensure the holes in the
pallet are aligned with the holes in the side panel before fastening.
Note: If the bolt heads were not previously set flush with the plywood, clearance
holes need to be drilled in each panel to allow these to sit against the plywood pallet.
•
Refer to Section 3 in this manual to install the light fixture(s) to the end of the ceiling rod.
Refer to either Single Ceiling mount or Dual Ceiling mount accordingly.
Ceiling
Rod
Trolley
Assembly
Cable Carrier should have a
Simple Radius
FIGURE 30: Power Cord Placement
Cable Clamp
Cable Carrier
