Nuvo NV-WCPS, Installation And User Manual

Page: 21 / 40

The following is a quick reference table that describes the different LED responses for
the Repeater.
LED status What it means What to do
On solid The Repeater has found a Coordinator but is
not linked to that Coordinator yet. Press SETUP button on Coordinator and then press
SETUP on the Repeater.
Off The Repeater has found a Coordinator and
established a link. No action required. Repeater is functioning properly.
Blinking slowly The Repeater is trying to establish a
connection with a Coordinator. It may take up
to 20seconds to re-establish a connetion after
startup.
Make sure the Repeater is within range of the
Coordinator and the Coordinator is powered on.
Otherwise, it is possible that factory defaults have
been restored on the Coordinator and it is no longer
allowing the Repeater to reconnect. Press and hold
the SETUP button to restore factory defaults. Repeat
the setup procedure.
Blinking rapidly Error condition. Make sure the rotary switch is in the 'R' position. If
this does not solve the problem, try restoring factory
defaults on the Repeater by pressing and holding the
SETUP button for 2 seconds. If the fast blink
persists, call NuVo tech. support.
18
Once a link has been established, tapping the Setup button on the Repeater will test
the connection to the Coordinator. If a good connection exists, the LED will turn on and
back off quickly.