Nuvo NV-T2DAB, Installation Manual

Page: 13 / 28

8
FM and DAB Antenna Installation (Fig. 4)
The T2DAB is not shipped with an FM or DAB antenna. Any
after-market FM or DAB antenna will supply a signal. The
connection for both antennas is done with standard 75 ohm
RG6 coaxial cable. A separate “F” connector for both signal
inputs are provided on the T2DAB back panel.
Note, that signal quality is greatly affected by the location and
quality of the attached antennas. Often, best reception is
achieved by placing the antennas as high as possible.
Connecting for NuVoNet Use (Fig. 5)
Once audio outputs A and B are set for NuVoNet, the T2DAB is
ready to communicate in real time with the Grand Concerto or
Essentia E6G audio distribution systems. To complete the
connection, all that is necessary is a single CAT5 cable from the
NuVoNet output on the T2DAB's back panel to one of the Device
inputs on either the Grand Concerto EZ Port or the Essentia E6G
Allport. Since the outputs of the Tuner must be set as a specific
source number input for NuVoNet communication, the number
of the Device connection used is irrelevant to the system's
operation. Once the connection is complete, the tuner is ready
to fully communicate with NuVoNet.
IR Control of the T2DAB (Fig. 6)
The T2DAB can be used without NuVoNet as a standalone dual
tuner. The IR receiver is always active, however control through
IR is typically done in Standalone mode,(see section
I. Setting
the Audio Outputs for NuVoNet or Standalone use, pg. 7).
Once the audio outputs are set at Standalone, the T2DAB offers
three methods for IR control. One is to take the IR output of
your control device using a mono 3.5mm patch cable into the
Direct IR input on the back panel of the T2DAB. Tuners A and B
feature discrete commands, allowing both tuners to be
controlled independently from one input. The second method
for IR control is to attach an IR emitter over the IR receiver on
the front panel, and the third method is to aim the remote
control at the IR receiver located on the front panel.
Fig. 4
Fig. 5
MENU
OK
Jozef Kossovit
SIR
SR 86 (P101)
SIRIUS Pops
3:09 PM
Hungaria
07 28
3033118
ERTE T K N
I
CM
Model NV-T2DAB
Du al AM/ FM Tune r
ww w.nu vo te ch no lo gi es .c om
Nu Vo Techn ol og ie s LL C He br on , KY USA •
CO NF OR MS TO UL
ST D. 60 06 5 CE RT IF IE D
TO CAN /C SA ST D.
C2 2. 2 No .6 00 65 :0 6
RS 232
SYSTEM
NuVoNet IR INPUT
RoHS
SYS ON
EXT. MUTE
SYSTEM ZONE TRIGGER OUTPUTS NETWORK
SUM1
EMITTER OUTPUTS
3033118
C US
R
CONFORMS TO
UL STD.6500
CERTIFIED TO
CAN/CSA STD.E60065
NuVo Technologies Cincinnati Ohio USA
FUSE:T5 A 120V 60Hz 500W
MODEL NV-I8M
SIX SOURCE EIGHT ZONE
AUDIO DISTRIBUTION SYSTEM
www.nuvotechnologies.com
DIGITAL LINK
VARIABLE
OUTPUT
FIXED
OUTPUT
TIP=L
RING=R
VARIABLE
OUTPUT
FIXED
OUTPUT
TIP=L
RING=R
VAR.
OUT
FIX.
OUT
PROGRAM
1 2 3 4 1 2 3
CONNECT TO
NV-I8X
USE NV-SLC1
CABLE
CONNECT TO
NV-I8EZP1
USE NV-NC1
CABLE
USE CNLY WITH 250V FUSE
4 5 6 SUM2 5 6 7 8
ZONE 5 ZONE 6 ZONE 7 ZONE 8
RS 232
SPEAKER
40W/6 OHMS X 2
LEFT RIGHT
SPEAKER
40W/6 OHMS X 2
LEFT RIGHT
SPEAKER
40W/6 OHMS X 2
LEFT RIGHT
0728
3033118
RT E E T K
N I
CM
Model NV -T2 DAB
Dual SIRI US Ready AM/FM Tuner
www.nuvot echno logi es. com
NuVo Techno log ies LLC Hebr on, KY USA
•
CONFORMS TO UL
STD.60 065 CERTIFIED
TO CAN/CSA STD.
C22.2 No.60 065:0 6
RS 232
SYS TE M
NuVoNet IR INPUT
RoHS
Fig. 6
L
AUDIO
R
TUNER A
L
AUDIO
R
TUNER B