suggested to put a pillow beneath your back so that you can keep
your back straight. Uncomfortable posture and unsteady breathing
may lead to blockage of the respiratory tract.
Please sit correctly with proper posture before starting-up the
device. Take long breaths steadily and slowly so that the nebulised
liquid may be inhaled deeply into the respiratory tract.
Press the ON/OFF switch if you want to stop the nebulising during
treatment; the device will be shut down automatically whenever
the liquid is used up.
When no aerosol comes out you can check the nebuliser head
lightly after power off.
During nebulising, the maximum permissible tilting angle of the
device is 45° (from the vertical line). If the angle is exceeded, the
liquid may spill from the metal mesh in the nebulising head.
If an operating device is tilted to the extent that the liquid is not
in contact with the nebulising head, the device will shutdown after
a delay time of 10 seconds (depending on the liquid type).
When there is not much liquid left, you may tilt the device towards
yourself to allow liquid gathered at the nebulising head side in
order to make full use of the residual liquid. During operation be
cautious not to shake the device because it may cause device
malfunction, such as automatic shutdown.
7. After completion of treatment, shut it down by pressing the ON/OFF switch; if
power adapter is connected, you are also required to unplug it.
8. Remove the mouthpiece/mask and the connector in an order reverse to the
corresponding installation order.
9. Remove the outer cover.
10. Remove the nebuliser
Hold the main unit with left hand, press the PRESS-
key (over the port for the adapter) with your left
thumb along the direction of arrow (see Fig. 13); hold
both sides of the lower end of nebuliser the right
hand to gently pull it out.
11. Remove the residual liquid, empty the nebuliser, and clean the device.
For details please refer to the section – Cleaning and Disinfecting.
Note: You are advised to, after each use, allow the device to run with clean water
instead of liquid for 1-2 minutes in order to clean the nebulising head.
