enviolo Assembly Instruction
21
N
Manual system:
INSTALLING THE SHIFT CABLES
•
Install cable end hardware only by pulling
cables at the end of the housing.
Never rotate the grip with cables
unattached, as they can bind inside the
barrel adjuster.
•
Pass the shift cables through the
appropriate cable housing and ensure
the housing is seated completely into the
shifter.
•
Thread both barrel adjusters completely
clockwise (in) to provide maximum
installation slack.
•
Pull the underdrive shift cable, marked
green or black, firmly at the rear
axle location until it stops, checking
to make sure that the shift indicator
[N]
goes completely flat (enviolo TR and SP
controllers), or that the grip rotates
fully in the counter-clockwise direction
shown (enviolo CT, CA and CO shifter,
viewed from the right side of the bicycle).
•
Pass the underdrive shift cable through
the UD cable stop
[O&P]
and secure the
UD cable stop at the distance shown
[O&P]
while pulling the cable firmly.
•
Ensure that the cable housing is seated
fully at the barrel adjuster.
•
Using a 2mm allen, secure the cable and
torque to 1.5-2.0 Nm (13-18 in-lbs).
120
mm
O
120mm for Standard controller
P
82
mm
82mm for One-Turn
