enviolo Assembly Instruction
20
L
Manual system:
INSTALLING THE SHIFT CABLE HOUSING
•
Route cable housing as shown from the
controller to the manual hub interface.
•
Measure, cut and install the appropriate
length cable housing for the bicycle.
•
Full-length housing is recommended for
both shift cables.
•
Make sure that the cable housing lengths
are sufficient to allow an extreme turning
angle. Also consider the influence of
adjustable handlebars and stems on the
cable housing lengths.
•
Secure cable housing to the frame. The
cable housing must remain moveable
for axle adjustment.
•
Avoid tight bends when installing the
shift cable housing.
•
Leave at least 150mm of housing
unsupported at the manual hub
interface to ease installation and
removal of the shift cable hardware.
•
With the housing length correct, install
end caps at both ends of each
housing.
1
2
underdrive
overderdrive
M
The underdrive cable end
should be colored green or
black. The overdrive cable
end will be uncolored.
Ensure the housing
diameter is correct. Too
big or too small diameters
can have a negative
effect on shift forces and
performance.
