Nussbaum TOP LIFT TSK 12000 DJ, Operating Manual, Inspection Book

Page: 7 / 56

Operating Manual and Inspection Book
TOP LIFT TSK 12000 DJ
- 7 -
• Care must be taken as burns may occur from touching hot parts.
• Do not operate the Lift with a damaged cord or if the Lift has been damaged –
until it has been examined by a qualified service person.
• To reduce the risk of fire, do not operate Lift in the vicinity of open containers of
flammable liquids (gasoline).
• Adequate ventilation should be provided when working on operating internal
combustion engines.
• Keep hair, loose clothing, fingers, and all parts of body away from moving parts.
• Use only as described in this manual. Use only manufacturer’s recommended at-
tachments.
• Always wear safety glasses. Everyday eyeglasses only have impact resistant lenses,
they are not safety glasses.
• The proper positioning of the carrier plate below the vehicle is to be checked again
after the vehicle has been raised slightly.
• After each set down of the vehicle, check the lifting arm positions below the fixture
points again and adjust as required.
• When disassembling heavy, consider any possible centre of mass shifts. The vehicle
is to be appropriately secured using suitable materials (e.g. tensioning belts,
beams, etc.) against falling.
• After design and maintenance on load bearing parts the lift must be inspected by
a technical expert.
• Vehicles may only be attached at fixture points approved by the vehicle manu-
facturer.
• The entire lifting and lowering process is to be continuously observed.
• Initial access to the lift is only permitted after the main switch has been turned off
and secured, and the operating lever is additionally secured against unauthorised
use.
Save these instructions!
1.6 Safety devices
Nussbaum has designed several saftety features into each Lift to ensure safe and effi-
cient operations under a variety of conditions. Warranties will be voided and danger-
ous working conditions exist if any of the listed devices are altered or disabled.
• Over-pressure valve
Hydraulic system fuse against over-pressure.
• Check valve
Secure the vehicle against unauthorised lowering.
• Main switch with curtain lock device
Fuse to prevent unauthorised use.
• Command / downstream system with latch
Secure against unauthorised lowering of the lift.
• Deadman controls
Lift movement stops when the operating lever is released.
• Lifting arm block
Secures the lifting arm against horizontal movement in a lifted condition.