Nussbaum TOP LIFT TSK 12000 DJ, Operating Manual, Inspection Book

Page: 6 / 56

Operating Manual and Inspection Book
TOP LIFT TSK 12000 DJ
- 6 -
Information of warning
Pay close attention to the danger and important information symbols shown below.
Carefully read all marked passages throughout this manual.
Danger! This sign indicates danger to life. Improper handling of the de
Scribed operation may cause serious injury or death.
Caution! This sign warns against possible damage to the automotive Lift or
other material defects in case of improper handling.
Attention! This sign indicates an important function or note.
1.5 Safety regulations
The Safety Regulations must be observed and strictly adhered to while working with
the automotive Lift. Read the safety regulations and the ANSI/ ALI ALOIM manual in-
cluded with the lift documentation carefully before working with the Lift!
Important safety instructions – read all instructions
•
The total weight of the lifted vehicle must not exceed 12000 pounds.
• The automotive Lift must be in its lowest position, and the Lift Carry Arms must be
swung out before a vehicle can be driven into the Lift area.
• Total load must be distributed evenly on all arms.
• The Lift must not be installed in a hazardous location or in washing bays.
• The Lift must be checked by a service technician after initial installation and after
repairs or changes have been made to the Lift.
• The operating and maintenance instructions must be followed while working with
the Lift.
• Pre-check low clearance or specially equipped vehicles for ample clearance to
avoid damage to the vehicle and/or Lift.
• Only trained personnel are to operate the Lift.
• No one is to stand within the working area (danger area) during vehicle lifting and
lowering operations.
• No one is to occupy a vehicle during any phase of Lift operation.
• No one is to climb onto the automotive Lift when in a raised position.
• For unusual vehicles you may choose to instruct the user to contact Nussbaum for
lifting advice.
• The main electrical switch must be switched off and locked out or tagged out ac-
cording to OSHA Regulations before maintenance or repair work is performed on
the Lift.
• The operator must continue to observe the vehicle and Lift throughout the lifting or
lowering operation.
• Check the center of gravity of the vehicle if heavy parts, such as the engine are
removed.
• If heavy parts such as the engine must be removed, the center of gravity will
change. Secure the vehicle before removing parts to avoid the possibility of the
vehicle becoming insecure.
• Read all instructions before operating lift.
!