Quick Lube HF
Nussbaum Automotive Solutions, LP | 1932 Jordache Court, Gastonia, NC 28052 | 704.864.2470 | Email:
|
www.nussbaum-usa.com
9
7.2.
Instructions for Common Lift Maintenance
PART
ACTION/PRODUCT
Clean the Piston-Rod.
Use compressed air.
Check Oil Level.
Fill the tank with a clean, high quality AW32 oil.
Change the hydraulic oil at least once every 4 years.
To change the oil, lower the lift to its lowest position.
Empty tank and refill with clean oil. Approximately 2 Gallons
(If ambient temperature is under 40 degrees Fahrenheit, use lower
than 32 viscosity).
Dispose of used oil according to the appropriate regulations.
Check all welded joints for cracks.
If any cracks are found on the lift, stop use immediately. Switch-off
and secure the power supply and call service provider.
Check all external surfaces for damage.
If damaged, repair immediately. If repairs are not made
immediately, permanent damage to the powder-coated surface may
result.
Repair and clean damaged areas with an abrasive paper (120 grit).
Coat repaired area with a suitable paint (observe the RAL Number).
Check Zinc Surface. White rust can result from
moisture laying in certain areas for long periods of
time or poor ventilation. Poor ventilation can also
result in rust formation. Rust may result from
mechanical damage, wear, aggressive sediments (de-
icing salt, liquids), or insufficient cleaning.
Repair and clean these areas with abrasive paper (240 grit). Coat
repaired area with a suitable paint (observe the RAL Number).
Check all safety devices.
All safety devices must be in good working condition. If not, contact
Technical Service.
ONLY USE REPLACEMENT PARTS THAT ARE PROVIDED BY OR RECOMMEND BY NUSSBAUM AUTOMOTIVE SOLUTIONS
CONTACT TECHNICAL SERVICE ABOUT REPLACEMENT PARTS
