Quick Lube HF
Nussbaum Automotive Solutions, LP | 1932 Jordache Court, Gastonia, NC 28052 | 704.864.2470 | Email:
|
www.nussbaum-usa.com
13
11.2.
Prepare Lift Assembly Location
Attention!
These locations are merely guidelines. The shop owner
should always be consulted to determine work habits, vehicles
serviced and preferences of the shop technicians.
The installation of the lift is performed by manufacturer trained technicians or by the manufacturer’s distribution
partner. The lift owner may use their trained mechanics to install the lift. The installation must be performed
according to the following regulations:
Lift is intended for indoor installation only. Installation in an outdoor application is prohibited and will void the
warranties of the product.
Always consult a qualified person regarding local regulations for seismic requirements.
Do not install lift in hazardous locations, depression areas, or washing stalls.
Concrete must have compression strength of at least 3,500 PSI and be a minimum of 4 inches thick.
Mount on a level foundation.
11.3.
Establishing Front or Rear Platform Guidelines
The exact front/rear placement of the lift is entirely up to the discretion of the lift owner based on space
limitations and lift usage. The following are the MINIMUM guidelines we recommend for lift placement. It is the
responsibility of the lift owner and installers to determine how much clearance space is needed for the given
location to ensure safe use.
Establishing location from the lift front
:
Allow at least 8’ between the front of the lift platform and any
obstacles.
Establishing location from the lift rear
:
Allow at least 10’ from the inside of the door to the rear of the
platform.
11.4.
Concrete Foundation for Flush Mounting the Lift
If flush mounting the Quick Lube HF, follow foundation plans in Appendix 4 during pouring of concrete floor.
If not flush mounting, ignore this section.
12.
LIFT INSTALLATION
12.1.
Unpack container
Part
Quantity
Owner/Installation Manual
1
Power Unit
1
Lifting Platforms
2
High density blocks
8(4 Large, 4 Small)
Hydraulic Hoses
1 set
Platform Ramps (if above ground)
4
Flushmount Kit (if flushmounted)
Angled brackets (x4)
Top plate (x2)
M8x16 countersunk bolts (x8)
1
Attention!
Report any shortages immediately
