Nuova Simonelli Aurelia, User Handbook Manual

Page: 65 / 82

63
ENGLISH
• To change the settings, it is sufficient to
press the hot water button ; if the but-
ton is not lit, the pump will not be enabled
while hot water is being dispensed; if the
button is lit while hot water is dispensed, the
pump will be activated.
• Press the continual button for the sec-
ond dispensing group to confirm the setting.
TIMED STEAM PROGRAMMING
• Access the programming according to the
relative procedure.
• Press the steam selection key .
• Steam ejection will start.
• Establish the desired dose of steam and
press the key again .
• Press the continuous key to exit the
programming or to continue programming
other selection keys.
AUTOMATIC CUP-WARMER PROGRAMMING
• Access the programming according to the
relative procedure.
• Press the cup-warming selection key
.
• The delivery keys of the first and second unit
will respectively signal the allotted automatic
switching on and off times while the continu-
ous
keys of the first and second units
will flash on and off.
As described in the chart, each delivery key
has an associated value, the starting up time
of the cup-warmer is given by adding up the
Keys 1° GROUP
(time ON)
2° GROUP
(time OFF)
2 minutes 5 minutes
4 minutes 10 minutes
8 minutes 20 minutes
16 minutes 40 minutes
LEVELLING PUMP ACTIVATION
• Access the programming of the first group
according to the relative procedure.
• Press the second unit continuous
key (the key will light up).
• Press the second unit 1 small coffee
key.
NOTA: If the I small coffee key is lit up,
the pump will start up during the level.
If the 1 small coffee key is not lit
up, the pump will not start up during the
level.
• Press the second unit continuous
key.
In this way the selected pump setting is
stored.
• To exit the programming, press the first unit
continuous key.
values of the first unit’s lit-up keys. The same
counting method is used for the cup-warmer
switching off time with the keys of the second
unit.
NOTE: The settings will be saved even when
exiting the first unit programming direct-
ly.
ADJUSTING KEYBOARD LIGHTING
INTENSITY
• Access the programming of the first group
according to the relative procedure.
• Press the second unit continuous
delivery key.
• The second unit 2 long coffees delivery
key will flash on and off.
• Press the key more than once to vary the
light intensity.
NOTE: You can set a maximum of five different
degrees of light intensity.
• To store the set light intensity values in the
memory, press the second unit continuous
delivery key.
• To exit the programming, press the first unit
continuous delivery key .
NOTE: The settings will be saved even when
exiting the first unit programming direct-
ly.