Nuova Mondial Mec MANTA COMPAT 200 LX, User Instruction And Maintenance Manual

Page: 59 / 87

301009_R00_IT
Page 59 of 87
10.5.5 Disk Cutting Height Positioning
The maximum depth of the cutting tool (disk blade), as well as the maximum free lift between the work
surface and the electric motor, are fixed values predetermined by the manufacturer according to the
model of the machine indicated in Chapter 2 of the manual under the machine technical data section.
It is therefore recommended to always check whether these characteristics are compatible with the
size of the material you intend to cut.
The adjustment of the height of the disc on the machine it is essential to allow a choice of suitable
cutting depth with respect to the work surface.
Proceed to the adjustment based on the version of the machine in use by means of:
a) Manual version : a mechanical hand wheel located on the cutting head
b) Semi-automatic version : the joystick on the control panel of the electrical box (see
Command modes for the semi-automatic version)
For both versions, lower the carriage of the head until the cutting disc is about 1 cm under the work
surface.
It is recommended that all the machine control operations be performed without loading material on the
work surface so as to avoid damage or disruption due to accidental contact. Do not perform operations
without the blade disk guard in place and fastened with the fasteners into place.
10.5.6 Disk Positioning for inclined cut at 45 °
To perform this operation we recommend the use of 2 persons and positioning the carriage to the rail
center.
To execute inclined cuts:
1) Unlock the two levers on the carriage (ref. 2 Image 13 procedure for inclination of the cutting head
to 45 °); you will notice a downward fluctuation in the engine.
2) Insert the rods Ref. 1 in the appropriate slots Ref. A
3) Raise as in ref. B up to the stop of 45 ° then tighten the two levers Ref. 21.
Image 13 procedure for inclination of the cutting head to 45 °