Numatic TRO 650/200T, Owner'S Instructions Manual

Page: 8 / 32

Machine Set-up Guide
8
www.numatic.co.uk
Featuring the OBS (Octagonal Brush System);
the brushes simply push-fit up onto the chucks
making fitting and removal a simple process.
Pull the side pod adjustment lever and set to the top position (Fig.14) .
The side pod will now pull open (Fig.15) .
Fit outer brush next on both sides (Fig.16) .
Close side pod.
Safety gloves are recommended for the changing of used brushes.
Fitting the Brushes
14 15
16
The TRO 650 / 200T is equipped with a large capacity 120 litre clean-water tank allowing, for large areas to be covered
in a single fill. To fill the clean-water tank, lift the cover flap (Fig.17) to expose the filler cap.
Unscrew the filler cap (Fig.18) and fill the tank using a hose (Fig.19) or preferred method.
Filling the Clean-water Tank
17 18 19
The water level in the clean-water
tank can be measured using the
scale on the rear of the machine
(Fig.20) .
Always ensure that the waste-water
tank is empty before lifting.
20
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not
allowed to enter the clean-water tank during the filling process. If using a bucket or similar,
ensure it is always clean and free from debris.
! !
Fill-level indicator