Numatic TRO 650/200T, Owner'S Instructions Manual

Page: 14 / 32

14
www.numatic.co.uk
The Floor Tool
31 32
Floor-tool overview
1. Floor-tool main body
2. Rear blade
3. Blade carrier
4. Front blade (slotted)
5. Retaining pins x 4
1
2
3
4
5
To clean the floor-tool, remove securing-pin and disconnect the lifting strap and remove the floor-tool securing pin
pull-free the floor-tool from the rear of the machine.
Rinse the floor-tool assembly with clean water and refit.
Periodically the floor-tool blades should be examined and checked for wear and damage.
The blade removal is easy. Simply start by removing the four retaining pins (see Fig.30), turn the floor-tool over and
separate the blade carrier from the body (see Fig.31). Peel away the blades from their locating lugs (see Fig.32) and
examine or renew as required. Replacement is a reversal of the removal process.
The TRO 650 / 200T is provided with the aluminium floor-tool shown.
30
Changing the Floor Tool Blades
ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED
PRIOR TO ANY MAINTENANCE
! !
Note: Floor Tool adjusters are factory set for optimal performance.
The blades are designed to be reversible, thus extending their useful working life.
! !