Nukeproof MEGAWATT 297 2021, Manual, Page: 8 / 78

M E G A W AT T B I K E G U I D E 2 0 2 2 | 8
S E C T I O N 2 - A s s e m b l i n g y o u r b i k e
This section details how to get your bike ready for setting up and riding out of the box, this will
be relevant for mail order bikes, generally the following will be done already if purchased and
collected through a local authorised Nukeproof dealer.
F I T B A R S
1. Unscrew face plate bolts from stem with a
4mm Allen Key, remove stem face plate and
bolts, set aside safely for installing later
2. Place bars to stem, using the set-up lines to
position the bars centrally. Ensure cables and
brake lines are not tangled at this point
3. Tighten the face plate bolts to the stem with
a 4mm Allen Key, start with the top bolts and
move to the bottom bolts. Ensure bolt torque
is evenly spread around all four bolts before
fully tightening. Reference the torque details
on the stem
4. Two SD50 wires need to be installed to the
display on the handlebars. Place the SD50
wire in the EW300 tool, ensure the wire is
seated correctly in the EW300 tool to ensure
correct fitting