Nukeproof MEGAWATT 297 2021, Manual, Page: 23 / 78

M E G A W AT T B I K E G U I D E 2 0 2 2 | 2 3
I N S T A L L I N G W H E E L S W I T H T H R O U G H A X L E S
*In some cases, if you have mail ordered, your chosen authorised Nukeproof Dealer may have
shipped the bike without wheels installed. Please reference the following to install wheels with
Through Axles to your bike.
Nukeproof bikes typically will use Through Axles.
Insert the wheels to the fork and frame dropouts, ensure the rotor is aligned with the caliper to
avoid damage when installing. For the rear wheel please ensure the gears are in the smallest
sprocket and pull the derailleur rearwards to give more room for install. Ensure the hub endcaps
are seated correctly in the dropouts for a secure fit.
Apply a little grease to the axle and threads and push through the dropouts and hubs until axle
cannot be pushed further.
Tighten the Through Axle clockwise to the Nm found on the axle, if no Nm is displayed, please
consult with your Nukeproof Dealer.
If the Through Axle is stiff when installing, it may be cross-threading, stop immediately and check
seating of hubs and dropouts. Any further concerns please consult with your Nukeproof Dealer.
If the forks have pinch bolt dropouts, reference the forks manufacturer guides for correct
installation.
If the Through Axles have Quick Release levers, please reference the axles manufacturers
instructions for correct install.
Ensure the correct tools are used when fitting and removing Through Axles, if you are unsure,
please consult with your Nukeproof Dealers.
Ensure the Through Axles are checked before and after each ride to ensure they are tight.
Riding with loose Through Axles can result in loss of control, injury and death.
If you are unsure on fitting wheels with Through Axles, please consult with your Nukeproof Dealer.