NUK MEDICPRO 10.256.467, Operating Instructions Manual

Page: 27 / 58

25
9. Technical data
Dimensions: 160 x 135 x 175 mm
Weight: 1.5 kg
Power supply: 220-240 V
~
/ 50-60 Hz
Power consumption: 3.4 A / 900 W
Degree of protection: I
Protection class: IP22
Environmental conditions:
- Operation:
temperature: +15 °C to +37 °C
humidity: 20% to 65% RH
- Storage / transport: temperature: -10 °C to +50 °C
humidity: 20% to 90%
Filter used: class G3
Indicator is lit up red No bottle in
device, device is
still warm
Device can be used: Insert bottle and press oper-
ating button
5
Bottle/food too
hot Check food temperature.
Select suitable bottle size: With small quantities of
liquid, use small bottles
Bottle size not
suitable for quan-
tity of liquid Select suitable bottle size: With small quantities of
liquid, use small bottles
Indicator flashing
red Critical fault Do not continue using device. Contact Service
(see “Contact addresses“ on page 55)
Device not
responding Device not con-
nected to power
supply Check and connect if necessary
Overheating cut-
out tripped (fuse) See “5.4 Overheating cut-out” on page 23
Food too cold Quantity of liquid
to be heated is
very large Heat bottle again (see “5.1 Heating food“ on
page 22)
Food too hot Bottle size not
suitable for quan-
tity of liquid Select suitable bottle size: With small quantities of
liquid, use small bottles
Surface of device is
getting very warm /
hot Filter clogged Replace filter (see “7.1.1 Replacing the filter“ on
page 24)
Air inlet is blocked Air inlet should not be blocked (see “4.2 Setting
up“ on page 21)
The fan in the device
continues to run
even though the
heating of the bottle
has been completed Unit is still too hot
and must be
cooled down None, the fan switches off automatically after
sufficient cooling
Problem Possible cause Measures
Flaschenwärmer Hospital Rev418.book Seite 25 Donnerstag, 30. Juli 2020 12:47 12