NUK MEDICPRO 10.256.467, Operating Instructions Manual

Page: 25 / 58

23
The device then switches off. The LED indi-
cator goes out.
9. If taking out the bottle later, make sure you
always check the temperature of the food
before feeding Baby.
5.2 Thawing food
If a bottle is placed in the bottle warmer with
a temperature lower than 3
°C, the device
detects this temperature automatically and
starts the thawing process. The LED indica-
tor
1 lights up purple.
From a preprogrammed temperature thresh-
old the bottle warmer then automatically
switches to the heating process. The LED
indicator
1 lights up blue.
5.3 Colours shown by the LED
indicator
The colour of the LED indicator 1 shows the
current operating status:
5.4 Overheating cut-out
The device also has an overheating cut-out
to rule out the risk of fire in the event of
overheating. If it trips, this device can only
be replaced by a specialist or by the
manufacturer. Contact the relevant service
address (see "Contact addresses" on
page 55) for this purpose.
5.5 Switching the device off
manually
To interrupt a process and switch the device
off manually, hold down the operating but-
ton
5 down for at least 2 seconds.
The device switches off and the LED
indicator
1 goes out.
Please note that the fan in the device may
continue to run for some time and switches
off automatically.
6. Cleaning and disinfecting
Note: Cleaning and disinfection of the
device is solely performed according to the
relevant official operating procedures of the
hospital. They may vary depending on the
institution.
For this reason the following information
should be understood only as recommenda-
tions.
Should you prefer a different cleaning and
disinfection method, please consult the
manufacturer beforehand.
Warning! To avoid the risk of elec-
tric shock, injury or damage:
– Always pull the plug out of the
power supply socket before
cleaning the device.
– Allow the device to cool down
before cleaning it.
– Never immerse the bottle warmer 2
in water.
Colour Significance
Purple Food is being thawed
Blue Food is being heated
Flashing
blue
Check the position of the bot-
tle
Green Food has reached feeding
temperature and is being kept
warm
Red Food or device are too hot
Flashing red A fault is present (see
“8. Help with problems“ on
page 24)
Colour Significance
Flaschenwärmer Hospital Rev418.book Seite 23 Donnerstag, 30. Juli 2020 12:47 12