NUK Eco Control Plus Video, Operating Instructions Manual

Page: 41 / 230

41
In addition there are messages on the parent unit screen signaling low battery: ‘BATTERY
LOW’ if the battery of the parent unit is empty and ‘BATTERY LOW AT BABY UNIT’ when the
battery of the baby unit is empty. Replace batteries of the respective unit or connect the unit
with the mains adapter to mains.
5.4 POSITIONING
Set the units on a firm, level, dry and non-flammable surface. The bottom of the baby unit is
equipped with a tripod attachment point (chapt. 1.4). You can use it to screw the unit onto a
stand or tripod (not included in the pack, contact your retailer).
Make sure the power cable of the mains adapters are safely tucked away to prevent your baby
or child from strangulation and others from tripping and falling. Never place the baby unit inside
the baby’s cot, bed or playpen.
WARNING! Strangulation hazard! Always keep cable out of children‘s reach. Do not use
the units with an extension cord.
Position the baby unit at a minimum distance of 1 meter (3 ft.) from your baby to reduce
hazard of radiation.
For optimal connection position the parent and baby unit as high and as far away from metal
surfaces as possible.
Check the connection between the units each time before using.
Never cover the units (e.g. with clothes, towels or blankets).
5.4.1 Tilting the Camera
If the video on the parent unit’s screen is not adjusted as you wish, you may tilt the camera on
the baby unit. Unlock the camera by pulling it forward at the top (fig. 7). You can angle the
camera approximately 45 degrees downwards. Push the camera back in the housing to fix it in
position again.
It is not possible to rotate the camera to the left or to the right. You need to move the
entire baby unit.
6 OPERATION
Once you have started your baby monitor it operates based on the default settings (chapt. 6.1).
That means video is transmitted continuously. Sounds are transmitted when the baby cries
(sensitivity level 3). You will hear an alarm if the batteries are low. You will not hear an alarm if
there is no connection between the units, but the connection indicator and connections
reception strength indicator are working (chapt. 5.1 and 5.2). You will not hear an alarm when
the temperature exceeds the minimum or maximum limit.
The video settings do not affect the transmission of sounds. The transmission of sounds
depends on the sensitivity level. It triggers how often the baby unit searches for the parent unit
to transmit sounds. If you wish to hear very quiet sounds from the baby (= maximum sensitivity)
set sensitivity level to 5 (chapt. 7.1.1.).
17
18
19
20
Note