NUK Eco Control Audio 530D, Operating Instructions Manual

Page: 37 / 94

35
6. Operating the parent unit
6.1 Switching the parent unit
on and off
To switch the parent unit 11 on or off, press
and hold the On/Off button 17 :
– when you hear a beep and the Power
LED 18 lights up, the parent unit is
switched on;
– when you hear a beep and the Power
LED 18 goes out, the parent unit is
switched off.
6.2 Indicator LEDs
• The connection indicator 16 on the
parent unit 11 shows the state of the
connection to the baby unit 1 . It:
– lights up green when it has a
connection;
– flashes green when the baby unit is in
Eco-Mode and indicates that your
baby is sleeping peacefully;
– lights up red if the connection has
broken down or the baby unit is
switched off.
Notes:
– If the baby unit 1 is in Eco-Mode and
the parent unit moves out of range, the
connection indicator
16 will light up
red. You will also hear a beep every
30 seconds.
– As soon as the parent unit 11 comes
back into range, or the reason for the
breakdown in communications is
eliminated, the connection indicator
16
lights up green again indicating that the
units are able to communicate.
– When the units are first switched on,
the connection indicator 16 will initially
be red. The parent unit and baby unit
will set up a connection. As soon as the
connection is set up the display will
turn green.
• The power supply indicator POWER 18 :
– lights up green: the device is switched
on and the battery is fully charged;
– flashes green: the battery currently
being charged;
– lights up red and beeps at one minute
intervals: low battery warning. Within
about 15 – 20 minutes the parent unit
will switch off automatically. Please be
aware that this interval may be
reduced, depending on how you use
the device (for example, VOX level 5
uses more power than level 1).
• The display 19 with the 5 LEDs has three
functions. The LEDs are only visible when
in use.
– indicates the noise level in the nursery.
The more LEDs are lit, the louder are
the noises;
– indicates the different levels when you
are adjusting the volume. The more
LEDs are lit, the louder will be the
sound from the loudspeaker;
– indicates the different levels when you
are adjusting the VOX sensitivity. The
more LEDs are flashing, the sooner the
device will react to sounds. If 5 LEDs
are lit the device will switch to
continuous transmission.
6.3 Information on the display
The display 15 is illuminated and lights up
automatically as soon as you perform any
operation on the parent unit
11 .
To save power, the light will automatically go
out if you perform no further operations for a
period of 30 seconds.
The display
15 shows you the following
information: