NUK 10.749.057, Operating Instructions Manual

Page: 13 / 128

9
be used for a prolonged period, e.g. overnight
(see section 7.1 on page 9).
3. Clean the parts of the appliance (see
section 7.2 on page 9).
7. Clean and Maintain Appliance
Warning!
Always disconnect the mains plug
before filling, emptying, cleaning,
disinfecting or descaling the appliance.
7.1 Empty and Dismantle
1. Take water tank 3 off base of the appliance
9 (Figure 1).
2. Empty water tank 3 .
3. Tip out the rest of the water still in base of
the appliance 9 .
Caution! There is a marking (arrow) on the
base of the appliance to indicate in which
direction the water should be tipped out
(Figure 9).
4. Take off both parts of water level sensor 7
(locking washer and float ring) in an upward
direction.
Both parts are only pushed on.
7.2 Clean
The appliance should be cleaned after every
use, but at least once a week.
Caution! Use neither corrosive detergents/
scouring agents nor objects made of metal or
other hard materials, as these may attack the
surfaces.
Caution! Do not immerse base of the
appliance 9 in water or allow water to
penetrate it, as it contains electrical
components which could be damaged by this.
Important: Regular thorough cleaning of the
appliance after each use, but at least once a
week, will prevent limescale deposits building
up.
1. Rinse mist outlet 1 and both parts of water
level sensor 7 (locking washer and float
ring) under running water.
2. To clean base of the appliance 9 , wipe the
outside of it with a soft clean cloth after
every use (Figure 10). Clean the inside
carefully with a clean, damp cloth and use a
clean paintbrush for tight places if at all
possible.
3. To clean water tank 3 , place the tank upside
down on a level, dry and non-slip surface
and fill with 0.5l of boiling water.
Caution! Only put the screw cap on loosely
and do not screw it up tightly: an overpressure
could arise in the tank which might cause
material damage!
Allow the tank to cool down for at least 30
minutes and then empty it.
4. Allow all the cleaned parts of the appliance
to dry in the open.
7.3 Disinfect
The appliance needs disinfecting at least once a
week.
1. Place mist outlet 1 , both parts of water
level sensor 7 (locking washer and float
ring) and the screw cap together with its
rubber seal (removed) in boiling water for 3
minutes.
2. Fill base of the appliance 9 with about
200ml of boiling water, allow to cool for 30
minutes and empty in the direction of the
arrow (Figure 9).
Luftbefeuchter 1108 Seite 9 Mittwoch, 25. Februar 2009 10:21 10