38
high quality painted surfaces, is recommended. The
cleaning solution should be neither high acidic nor
highly alkaline; a pH range of 3 to 11 is
recommended. The cleaning solution should be free
of strong solvents or alcohol. Avoid contact of
window cleaners that contain ammonia
.
Damage Checks
It is important to periodically check the exterior for
damage. Pay attention to the following areas:
Waste tanks and plumbing lines.
Propane tanks and assembly.
Sealants around doors, roof, vents, and
window.
Exterior lighting.
Sealant Renewal
The adhesives and sealants used in the construction
of your camper were developed to remain
waterproof under sustained effects of weather and
vibration. However, even the finest materials will
eventually dry out and lose their effectiveness under
the constant heat of the sun, attack by other
elements and road vibration. This section outlines
the procedures that you must follow to maintain the
weather-resistant integrity of your camper.
WARNING
Leak damage caused by neglecting to follow
these procedures may affect your warranty.
Your
nüCamp RV
Dealer can perform the
resealing inspection and work for you and has
current information on sealants used in your camper
and can recommend the appropriate sealants if you
prefer to do this work yourself. Always use the
recommended sealants.
To protect your camper from possible water
intrusion damage, your unit should be inspected
thoroughly and resealed bi-annually. Inspect the
sealant around the roof moldings, windows, and
doors at least every six months. If any of the
following are evident during inspection, the affected
areas must be resealed:
Weathering or drying of sealant.
Sealant cracked or peeling.
Voids in sealant.
Shrunken or separated sealant.
Clean all areas to be resealed with mineral
spirits. Make sure that all areas to be
resealed are dry before new sealant is
applied.
Mineral spirits are a flammable liquid. Use
extreme care when handling. Do not expose
to open flame, sparks, or smoking materials.
Do not use in unventilated areas.
Check and tighten any loose fasteners. Be
careful not to over-tighten, or stripping will
occur.
If you find any of the above:
If areas on the roof need to be resealed, remove any
loose or cracked sealant being careful not to damage
the roof. Use a wooden or plastic scraper that will
not gouge, pierce, or otherwise damage the roof.
The roof can be cut or punctured by sharp objects.
Apply the new sealant in a continuous bead along
the seams and flanges, being careful not to leave
any voids. Apply enough sealant to flow over the
heads of all fasteners.
Allow at least 48 hours for the sealant to set
completely (firm and tack-free when pushed with
the thumb) before washing or waxing the camper.
Doors and Windows
Lubricate door hinges, locks, and window
mechanisms periodically or as need be with
powdered graphite if it becomes difficult to close or
squeaks. Be sure to inspect seals around the door
seal for tears or excessive dirt at least every 6
months or more often depending on usage. Clean
window frames and tracks to ensure easy operation.
Clean the glass windows inside and out, with a
commercially available glass cleaner. You can also
use a mixture of one-part white vinegar to ten parts
waters. This will remove the haze that builds up on
the inside of the glass windows. Use a soft cloth or
paper towels to clean all glass. Clean the seals with
a damp cloth or mild detergent every three to six
months, taking care not to use strong solvents, as
they will damage the seals. A coat of natural
silicone lubricant applied after the seal has dried
will keep it flexible. This is a good practice for all
the rubber seals in your camper. If the camper is
exposed to salt air, more frequent lubrication will be
required.