![background image](http://html1.mh-extra.com/html/nu-flame/fenton-balanced-flue/fenton-balanced-flue_use-installation-and-servicing-instructions_1715504020.webp)
20
o.
Now on the Outside check that the End Terminal part of the Flue is clear of the hole = 130mm of Flue, the Terminal should be clear of
the wall –
NOT WITHIN THE WALL
., (ensure all the square cut outs are outside the wall), See photograph below.
p.
Adhere Sealing Foam to back of the Wall Plate (see
Note
below). Fit and secure the Wall Plate to the Flue through the holes provided
in the flue terminal and seal to the Wall with the Stainless Steel Screws provided.
Note:
To prevent the ingress of water Sealing Foam has been supplied for the Wall Plate, if this does not provide an adequate
seal with the wall then any gaps must be filled with a waterproof silicone sealant or mastic.
Note:
With the flue at the correct length and when the fire is fitted there should be 130mm of Flue Terminal Outside The Wall
and the screw holes for fixing the Wall Plate should line up with those in the Flue Terminal.
! IMPORTANT NOTE !
NONE OF THE SQUARE HOLES IN THE FLUE TERMINAL MUST BE WITHIN THE WALL.
q.
Refit the Burner Assembly and secure with 4 screws, reposition the Thermatronic (Receiver Box and Infrared Sensor) or for High Level
Control the Battery Box onto their Velcro Pads if applicable. Reposition Receiver/Battery Box under Heat Shield.
r. Now Remove the Pressure Relief Cardboard Packer and Label at the Top of the Fire.
Ensure the Pressure Relief Door has remained closed (see photograph on previous page).
s.
Connect the isolation/pressure test elbow to the control valve and with it fully open check the joint for gas soundness.
t.
Check that all gas connections are sound. The appliance has been factory tested; however the connections may have been disturbed in
transit or storage.
! IMPORTANT NOTE !
Always reseal the pressure test point and check that it is gas tight.
(This accounts for a lot of recalls.)
WALL FIXING AND CABLE FIXING DIAGRAMS
When Cable Fixing If Necessary Recess The Eye Bolt To Ensure It Doesn’t Foul On The Surround Back Panel.
Side View of Cable Fixing System
Cable Fixing Hole Positions
360mm
510 mm
27mm
Top of Hearth
Side View of Wall Fixing System
Prize Tab Away
From Case
Eye Bolts
Eye Bolts
Spacer/Fixing
Brackets
Spacer/Fixing
Brackets
Fixing Screws
& Rawl Plugs