NTI XTENDEX 328 Foot HDMI USB KVM Extender over HDBaseT
13
Upgrade the Local Port Controller Firmware
The Local port controller firmware comes as a file in Intel Hex format and has the extension .hex (i.e. filename.hex). To upgrade
the Local Port controller with this firmware, press
<p>
from the terminal window. The following message should appear on the
screen:
Send .hex file using XModem protocol...
At this point, the hex format file
c6usbhe-lcpx-x.hex
has to be sent, using HyperTerminal and the same procedure as before.
When the transmission is done, the following message will be shown in the HyperTerminal window:
File transfer OK!
Please, type <A> to program chip or <X> to exit
To program the chip, just press
<
a
>
).
The following message will be shown on the screen (it may take about 12 seconds to program):
Programming device, please wait...
Device ID: 0x001E
Device successfully programmed!
To exit from the Local Bootloader, press
<x>
. (To upgrade the Remote Controller Firmware, you
need
to exit from the Local
Bootloader.)
Upgrade the Remote Controller Firmware
The Remote controller firmware comes as a file in binary format and has the extension .bin. (i.e. filename.bin). To upgrade the
Remote controller to this file, follow this procedure:
1.
With the power supply still connected to the Local Unit
, unplug the CAT6 cable between the Local and Remote Unit.
2. Press
and hold
the
<
Tab
>
key on the keyboard while in the HyperTerminal window
3. Plug the CAT6 cable back in (reconnecting the Local and Remote Unit). The following message should appear on the screen:
ST-C5-USBVA Bootloader
Revision: 1.5
Date: 2013/02/06 10:09:15
Copyright (C) 2010,2013 Network Technologies Inc
Press <H> for help…
>
4. Release the
<Tab>
key.
The
“
>
”
prompt indicates that the bootloader is waiting for commands. The available commands are composed by sending one
ASCII character. To send a command to the bootloader, type the key in the terminal window that corresponds to the desired
command. The available commands, listed below, can be viewed by typing <
h
> or <
H
> (the Help command) from the keyboard.
Note: Commands can be typed using upper or lower case letters.
Remote Bootloader List of Commands:
h, H - Display list of commands
x, X - Exit Bootloader
r, R - Upgrade Remote controller firmware