5. Click “Start” to perform the update.
6. After the update is complete it will show “PASS”
7. After the update, the DVI, VGA and MSG LEDs will illuminate. The MSG LED will go dark after a few seconds.
8. Now restore the unit to default settings one of two ways:
A. On the front panel press “Menu”, then “ –“ (Minus), then “–“ (Minus) again, then “ +” &” –“ (plus and minus at the same
time).
B. Using the IR remote, press Menu, then press 333, then press Enter. (This method only works on the Remote Unit).
The ST-IPUSBVD-VW will now be ready to use.
D:\ st-ipusbvd-l-v2.89.190830.UP
D:\ st-ipusbvd-l-v2.89.190830.UP
39
