Tx Series Installation and Operation Instructions
│
Trinity
9
Figure 3-2 Wall Mounting Instructions
Leave the
Top Wall-mount Bracket (A)
intact
and remove the
Bottom Wall-mount Bracket
(B)
that is attached to the bottom-back of the
appliance. Save mounting hardware for Step 4.
Secure
Bottom Bracket (B)
, removed from the
bottom back of the boiler in Step 1, to a solid
wall using field supplied lag screws (anchors
when mounting to a concrete wall) that are
adequate to support the weight of the appliance
(refer to Table 2-1 Specifications). Ensure the
bracket is level and flush to the wall. Mounting
holes to be on the bottom with flange pointed
upward and angled away from the wall.
Mount the appliance to the wall by aligning the
two wall mount brackets,
Top Bracket (A)
with the
Bottom bracket (B)
. Slide the top
bracket fastened to the boiler down over the
wall-mounted bracket until it hooks.
Once the appliance is resting securely on the
wall, attach the
L-shaped Bracket (C)
to the
underside of the appliance using the mounting
hardware removed in Step 1. Next anchor the
L-shaped Bracket (C)
to the wall as shown
using field supplied hardware.
Failure to follow instructions may
result in fire, serious injury, or death.
This unit requires two people to lift it
or damage and injury may result.
Top Bracket (A)
Bottom
Bracket (B)
Bottom
Bracket (B)
L-shaped Bracket (C)
shipped with boiler kit box
Wall
Boiler
Ensure Bracket
(A) fully inserts
into
Bracket (B)
(B)
(A)
