nStor NexStor 4200F Series, User Manual

Page: 90 / 174

Chapter 3 - Setup and Installation
Multi-TID Single Host-Dual Connection Configuration
78
9
Re-install the Disk I/O card. Repeat step 8 for the second Disk I/O card.
10
Set the SES Controller Card switches in the daisy-chain enclosure. Refer to the
illustration below.
SES Controller Card Switch Settings (Daisy-Chain)
NOTE: For additional enclosures, refer to the Device ID table for other
switch settings. See “SES Controller Card Switch Setting Overview”
on page 52.
11 Cable the daisy-chain enclosure to the primary RAID enclosure.
a Connect a data cable from the “P2” connector on the upper Disk I/O
card installed in the primary RAID enclosure to the “P1” connector on the
upper Disk I/O card installed in the daisy-chain enclosure. Refer to the
cabling illustration on the following page.
Disk I/O Card Jumper Settings for the NexStor 4000F Enclosure
JUMPER INSTALLED BOTH PINS INSTALLED ONE PIN (OFFSET)
JP1 Wahoo Controllers Only * Non-Wahoo Controllers
JP2 Wahoo Controllers Only * Non-Wahoo Controllers
JP3 Split Bus Mode
JBOD Enclosures Only * Single Bus Mode
RAID Enclosures and Daisy
Chain JBOD Enclosures
JP4 1 Gb/sec Bus Speed Mode * 2 Gb/sec Bus Speed Mode
* indicates default setting
IDs Assigned to Disk Slots
A
D
2 A
D
0
1 2 3 4 5 6 7 8
A
D
1 S
P
0 S
P
1 B
D
R D
L
Y
R
M
T
Switch Settings
ID 16
Slot 1
Slot 2
Slot 4
Slot 5
Slot 7
Slot 8
Slot 10
Slot 11
ID 18
ID 17
ID 19
Slot 3 Slot 6 Slot 9 Slot 12
ID 24
ID 25
ID 20 ID 22
ID 21
ID 23
ID 26
ID 27
UP (1)
DOWN (0)
4200F.book Page 78 Thursday, January 23, 2003 2:47 PM