background image

 

IMPORTANT SAFETY INSTRUCTIONS 

GROUNDING OF ELECTRICAL EQUIPMENT 

WARNING:

  

Improper connection of the equipment–grounding 

conductor can result in a risk of electric shock.  Check with a qualified 
electrician or service person if you are in doubt as to whether the outlet 
is properly grounded.  Do not modify the plug provided with the machine 
– if it will not fit the outlet; have a proper outlet installed by a qualified 
electrician. 

Always use a properly grounded 3-wire extension cord no less than 
12-3 ST, which has male and female plugs. 

GROUNDING INSTRUCTIONS

 

This machine shall be grounded while in use to protect the operator from electric shock.  The machine 
is provided with a three-conductor cord and a three-contact grounding type attachment plug. The plug 
must be plugged into a grounded outlet that is properly installed and grounded in accordance with all 
local codes and ordinances. The green conductor in the cord is the ground wire.  Never connect this 
wire to other than the grounding pin of the attachment plug. 

 

Check nameplate on the machine to be sure 

voltage

 and 

cycle

 stated is the same as the electrical 

outlet.  Do not attempt to plug a 120-volt machine into a 240-volt outlet or a 240-volt machine into a 
120-volt outlet.  If the machine is provided with an attachment plug as shown in Figure A. below, it is 
intended for use on a nominal 120-volt circuit.  If a properly grounded receptacle as shown in Figure A. 
is not available, an adapter may be installed as shown in Figure B. if the outlet box that houses the 
receptacle is grounded. Be sure to fasten the grounding tab (the green colored rigid ear, lug or the like 
extending from the adapter) with a metal faceplate screw. 

 

If the machine is provided with an attachment plug as shown in Figure C., it is intended for use on a 
nominal 240-volt circuit.  No adapter is available for this plug. 
 
 

 
 
 
 
 
 
 
 
 
 
 
 
NOTE:  In Canada, the use of a temporary adaptor is not permitted by Canadian electrical code. 

  

ALL REPAIR SERVICE MUST BE PERFORMED BY AN NSS AUTHORIZED 
DISTRIBUTOR / SERVICE STATION USING ONLY NSS ORIGINAL EQUIPMENT

                     

SAVE THESE INSTRUCTIONS

 

 

Summary of Contents for STALLION 12 SC











Reviews: