Maximum number of dimmers.
This parameter must be set to reflect a number greater than or equal to the maximum number of dimmer channels
installed in the system. The factory default is 32 dimmer channels. If this number is correct then this step may
be ignored.
The maximum number of dimmers may be set as follows:
1.
Make sure that the 400CP is in the program select mode as discussed.
2.
Press the zone 1 increase button and the BUSY led will quit flashing.
3.
Press button representing desired number of dimmers as shown in the diagram.
4.
If more than 256 dimmers are required then press a second button so that the sum of the values of the two
buttons pressed will equal the desired number of dimmers.
5.
The unit will exit this programming mode and the BUSY LED will start flashing again on release of the
second press, or after a few seconds if only one press was required.
400CP REMOTE CONTROL PANEL
PROGRAMMING
Software Revision 3.00, Version C
Maximum number of dimmers.
NSI CORPORATION
5
