13
NRG_34m_TallTower_Installation_Manual_and_Specifications_Rev_1.05.docx
19 April 2011
With the nut driver (or powered screwdriver), remove the 4 wood screws that fasten each end plate assembly down
to the wood pallet. Set aside the 2 end plate assemblies. If you can only remove one end plate assembly, that is OK.
Remove the end plate and set aside.
The tube contents will now be exposed. Beginning at the top, remove the contents of the tubes. These contents will
include: screw-in anchors, coils of cable, ground rods, guy rings, rocker plates, and the hardware kits.
At this point, there should only be 152 mm (6 inch) diameter tubes remaining on the pallet. With the band cutters, cut
the outer bands (#2 & #1) and center band (#3) as shown. Remove tubes.