6-in-1 POWER PACK Owners Manual
Page 12
061410
8&%,"-,$@%,;0<5=,;>/?
,
/01231456
Inflating other objects
1. Place the appropriate inflation accessory nozzle on the valve
connector and secure with the thumb latch.
2. Insert the accessory into the deflated object.
3. Turn on compressor via the switch on the front of the Power Pack,
once desired PSI is reached remove the valve connector by releasing
the thumb latch.
4. Turn off compressor via the switch on the front of the Power Pack.
Note:
If the maximum pressure of the item being inflated is not known,
then allow the compressor to run only until the desired fullness is reached.
Overinflating an item could result in damage to the Power Pack or the item being
inflated. Never leave the compressor running unattended.
Operating AC appliances
The output of the inverter is non-sinusoidal. If you are uncertain
that non-sinusoidal power will cause damage to a device, check
with the device’s manufacturer before proceeding.
TURN INVERTER SWITCH OFF AFTER EACH USE or battery
could be drained very quickly.
To power a 110V AC appliance with your Power Pack please follow these steps:
1. Turn on the power inverter (see Figure 2 on page 5 location L).
2. Plug in appliance.
3. Turn on appliance.
4. After use is completed, turn off appliance, unplug appliance from the
unit and turn off the power inverter.
5. Re-charge the Power Pack after each use.
Note:
To avoid unnecessary draining of your Power Pack’s battery, turn off the
power inverter when not in use.
Low Battery Shutoff
This time period will vary according to the wattage of the of the appliance in use,
state of Power Pack battery charge and temperature. This auto shut-off prevents
the Power Pack battery from becoming completely discharged and overheating of
the inverter which can cause permanent damage.
Do not operate AC appliances while charging your Power Pack. Doing so may
damage the unit and/or your AC appliance.
WARNING
WARNING
